Dmitry:

Yes, I can output in msgbox...I might also try LCase of Address to get out
of case sensitivity. OK??

Joel

"Dmitry Streblechenko" wrote:

Well, if the comparison fails, you can output the values, e.g. using MsgBox,
right?
First of all, e-mail adddress comparison should be cause insensitive.
Secondly, what you are seeing is a perfectly valid EX type (as opposed to
SMTP) address.

Dmitry Streblechenko (MVP)
http://www.dimastr.com/
OutlookSpy - Outlook, CDO
and MAPI Developer Tool

"Joel" wrote in message
...
TIA:

In earlier email I have following code:

Sub Send_Attachment_Messages()

Dim oFolder As Outlook.MAPIFolder
Dim Items As Outlook.Items
Dim objItem As MailItem
Dim Recips As Recipients
Dim Recip As Recipient

Set Items =
Application.GetNamespace("MAPI").GetDefaultFolder( olFolderOutbox).Items
For Each objItem In Items
Set Recips = objItem.Recipients
For Each Recip In Recips

If Recip.Address = " Then
objItem.Attachments.Add ("C:\copper\115.xls")
objItem.Send

ElseIf Recip.Address = " Then
objItem.Attachments.Add ("C:\copper\116.xls")
objItem.Send

ElseIf Recip.Address = " Then
objItem.Attachments.Add ("C:\copper\118.xls")
objItem.Send


End If
Next
Next
End Sub

When I run code in Outlook on non Exchange Server compute all is fine.

When I run code in Outlook that is networked with Excange Server, it
doen't.
Upon debug the Reciepient.Address value is something like
"/o=Company/ou/SUBCOMPANY/cn=Main Office=JonesB" certainly not
.
When I type the value as "o/=Company..." in the If test in my code, it
still
doen't match the actual emails and thus nothing gets attached.

One other fact..the email is generated from Word Mail Merge. I can see
the
values of EMail used by Word which is consistent with the data above
"o/Company..." but in Step Mode of Outlook Recip.Address appears as CAPS
but
it is not that way in the Word Merge Data Table.

Any ideas of what my code needs to be to match the EMail address as seen
in
the Outbox by my code. ie Recip.Address =
"/o=Company/ou/SUBCOMPANY/cn=Main
Office=JonesB" doen't work even though this is the value shown in Step
Mode.

Thanks very much,

Joel