![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
![]()
I'm unable to send out emails and told to enter an adddress or a name will be
used. However there ARE addresses clearly visible. I noticed that if I click on the SMPT so the 'OK' button becomes active - then the address will send. I don't want to click on 2500 addresses to 'activate' them......id there another way or is this not the problem? |
Ads |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
setup pop and smpt | Eugene | Outlook - Installation | 3 | November 17th 08 01:20 AM |
Internet Properties - Programs | Stevo | Outlook - Installation | 0 | December 4th 07 08:09 PM |
Outlook 2003 opens to Internet Properties - HELP! | Terri | Outlook - General Queries | 4 | June 28th 07 06:41 PM |
Outlook 2003- named properties v/s user properties ? | newToOutlookProgramming | Add-ins for Outlook | 2 | May 18th 07 07:38 PM |
Hostitel SMPT nebyl nalezen. Ověřte, zda je správně zadán název serveru. Účet: 'POP3', Server: 'SMPT', Protokol: SMTP, Port: 25, Zabezpečení (SSL): Ne, Chyba zásuvky: 11001, Číslo chyby: 0x800CCC0D | Milan Halčin | Outlook Express | 1 | March 13th 07 07:24 PM |