|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
April 18th 06, 09:54 PM
posted to microsoft.public.outlook.installation
|
|||
|
|||
RPC over HTTP requires port 135 Initial Configuration?
Howdy,
I just configured a new laptop with RPC over HTTP to an existing/working Exchange server with RPC over HTTP configured. I had to connect via a VPN to get the intial connection to Exchange working. Opening TCPView showed that the XP / Outlook 2003 client was trying to connect via port 135. Did I miss-configure the client so that it needed to do this? Is this a known requirement of the RPC over HTTP configuration, that you must make the initial with port 135? I haven't seen any documentation refer to this limitation of the initial connection, can anyone point me to some documentation on this? Thanks, Dan Foxley 
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RPC over HTTP | Jerry | Outlook - Installation | 0 | April 5th 06 05:11 PM |
| certificate for rpc over http | Sam | Outlook - General Queries | 1 | March 8th 06 04:05 PM |
| Hanging 5 minutes on send when using rpc over http | Stefan | Outlook - General Queries | 0 | February 13th 06 10:55 AM |
| rpc over http | jmiller | Outlook - Installation | 2 | February 5th 06 03:09 PM |
| RPC over HTTP problem for some users only | Ben | Outlook - Installation | 1 | January 31st 06 05:50 AM |
Threaded Mode