|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
December 24th 06, 10:09 PM
posted to microsoft.public.outlook.installation
|
|||
|
|||
Mailto Protocol
For some reason, when I try to start a new Outlook mail message either from a
link in a website or from a link in an email message, I get an error that says mailto protocal is not set up correctly and 50 blank webpages pop open! It is very frustrating. I have gone through and made sure my link was correct in my file types and have set Outlook as my defaul mail. Does anyone else have any suggestions? Thanks 
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Outlook and processing of Asynchronous Pluggable Protocol URL | scoroop | Outlook - General Queries | 1 | September 12th 06 10:52 AM |
| Switched to IMAP Protocol | Metallo | Outlook - Installation | 2 | August 26th 06 10:47 AM |
| Another "mailto" question -- mailto link that puts body of emails like "reply" does? | StargateFan | Outlook - General Queries | 12 | August 23rd 06 09:01 PM |
| Follow own-protocol-link in mail text | [email protected] | Outlook and VBA | 0 | July 13th 06 04:26 PM |
| I'm getting a protocol error when I send emails through outlook. | A.J. | Outlook - General Queries | 3 | June 7th 06 04:13 AM |
Threaded Mode