|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
November 8th 06, 11:26 PM
posted to microsoft.public.outlook.contacts
|
|||
|
|||
Accessing user defined fields
A few years ago I had created a user defined field "status" with Outlook
2003. Recently, we migrated to a new exchange server and now the system will not allow me to recreate that field. It says one already exists in the "all tasks" section. However, when I pull up a contact and select the "all fields" tab it shows the user defined field I created with the information I had populated. It also has the pre-exising field as well, with no information. How do I get my user defined "status" field back to show in the "phone list" view? Any help would be appreciated. 
|
| Ads |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adding User Defined Fields | Kevin Gal | Outlook - Using Contacts | 1 | October 31st 06 01:46 PM |
| Outlook Contacts - Converting User-defined Item fields to Folder fields | [email protected] | Outlook - Using Contacts | 1 | September 29th 06 10:17 PM |
| User defined fields | Darcy W. | Outlook - General Queries | 1 | September 16th 06 05:00 AM |
| Formatting User Defined Fields | Linda in Louisiana | Outlook - General Queries | 1 | April 18th 06 03:26 PM |
| user defined fields | Karl-H. Engesser | Outlook - Using Contacts | 1 | February 9th 06 03:33 PM |
Linear Mode
